Iqinvision Sentinel Series Manual do Utilizador

1IQeye Sentinel™ SeriesIndoor/Outdoor CameraInstallation and Operating Instructions

1011 Camera Arm InstallationThe back box is provided with arm hangers on both sides to hold the camera/arm module on the back box to facilitate insta

115. If mounting the unit outdoors, please take necessary and thorough measures to ensure the camera unit is properly sealed from inclement weathe

1212 Adjusting / Removing the SunshieldNOTE: For indoor applications of the Sentinel, the sunshield may be removed for aesthetic reasons. Though it i

13 b. Removal – With the set screw loose, pull the sunshield forward until it is free of the sunshield bracket. c. Optional – The bracket

144. To view a camera, double click a camera entry or highlight a camera in the list and click the “Web Page” button (Figure 14). The “Live” page

1514 Camera / Lens Adjustment / Remote Back Focus1. Using the supplied 3mm Allen wrench, loosen any two adjacent screws of the four available ball

164. Browse to the camera homepage and go to the Setup > Focus tab (Figure 20). 5. Set the iris on the lens to the ‘Open’ position then lock it

17The following image (Figure 22) is an example of an image focused enough to ensure a remote one-touch focus can be completed. NOTE: IQinVision prov

18Notes

1915 IQinVision 3 Year Limited Hardware WarrantyWarranty CoverageIQinVision, Inc. (“IQinVision”) warranty obligations are limited to the terms set fo

2Contents1 Unpacking ………………………………………………………...…………….2 Service …………………………………………………………………...….3 Description ……………………………………………

2033122 Valle Road San Juan Capistrano, CA 92675-4853 USA | phone +1 949 369 8100 | fax +1 949 369 8105 | www.iqeye.com901-0259 Rev A

31 UnpackingUnpack carefully. This is an electromechanical device and should be handled carefully. Check to ensure the following items are included:&

43 DescriptionThe Sentinel is a full featured, multi-megapixel H.264 Main Profile all-weather camera. With support for up to 5MP resolutions, this n

55 Parts ListThe following depicts the parts included (Figure 1):1. Indoor / Outdoor Camera and Lens Module 2. Wall, Ceiling & Parapet Arm3. Powe

67 Mounting Options8 Camera Arm RemovalNOTE: The camera/arm needs to be removed from the back box to allow the back box to be mounted to the designa

79 Mounting the Power / Data Back BoxBefore mounting the power / data back box, determine if the camera installation will be wall, ceiling, or parape

810 Terminating Power and Data Cabling Inside the Back BoxPower and data cabling must be routed to the right side (wall-side) of the back box. Cut al

91. Connecting Power: The IQeye Sentinel can be powered via Ethernet using an IEEE 802.3af power source, or powered directly. - Powered